Burst Generator SFT 2400 | 125 kHz

IEC / EN 61000-4-4

The Burst generator SFT 2400, 125 kHz with integrated coupling network simulates electrical fast transient (EFT) as defined in IEC / EN 61000-4-4 standards. Due to very short rise time of 5 ns, the individual pulses generate a broadband RF spectrum uo to 300 MHz.   

The simple operation takes place via a capacitive color touch display. All parameters are clearly displayed without nested menus and can be changed quickly by tapping and using a digital rotary encoder. The normative test levels 1, 2, 3 and 4 are programmed, additional test seuences can be stored via the memory function.

Kontakt / Contact
We will gladly advise you personally!

  • Burst frequency: Single pulse up to 125 kHz
  • Burst duration: 0.01 - 100 ms (limit parameters are automatically taken into account)
  • Burst period: 10 -1000 (limit parameters are automatically taken into account)
  • Pulse voltage: 100 V - 5000 V
  • Polarity of burst packet: positive, negative, alternating
  • Waveform according to IEC 61000-4-4: 5 ns / 50 ns
  • Capacitive color touch display
  • Max. Pulses / sec: 5000 (up to 2 kV), 3000 (up to 3 kV), 1500 (up to 5 kV)
  • Max. Pulses / packet: 500
  • Trigger: manual or external
  • HV output: coaxial socket
  • Monitor output: BNC, TTL level
  • Interface: USB (virtual COM port)
    Optional: optical (Toshiba LWL)
  • Internal single-phase coupling network
  • Weight: 9 kg

The pulse burst occuring in pratice does not comply with the definition of the standard. Its physical properties are deviating against the standard definition. The generator SFT 2400 provides the user a variety of special features such as "Real Burst", which simulates the natural appearence of the Burst pulse or "Noise" can be simulated with the contact bounce.

To localisation of faults, it is possible to couple the burst pulse very accurately to a certain process time of the EUT. The burst pulse microsecond exactly triggered with a jitter of <25 ns.

All burst parameters can be changed during a burst test. This guarantees that it can be easily and continuously to detect the fault threshold of the specimen. An interruption of the test for a parameter change at the burst generator is not necessary.

The optional EMC software "EMC-SOFT" enables the Schlöder interference generators to be operated from a PC via the USB port. The required serial interface cables are supplied for the respective devices. With EMC-SOFT, all parameters that can also be set directly on the generator can be operated remotely.

Our devices are perfectly harmonised with each other and can therefore be optimally combined (see illustration CWG 2500 - SFT 2400 - CWG 520). Their intuitive operation and remote capability via EMV-Soft make them extremely user-friendly.